當前位置:上海力孚同科技有限公司>>高頻電刀干擾測試>>電刀干擾測試治具>> 高頻電刀中性電極溫升測試儀
| 產地類別 | 進口 | 價格區間 | 面議 |
|---|---|---|---|
| 應用領域 | 醫療衛生,生物產業,航空航天,制藥/生物制藥,綜合 |
高頻電刀中性電極溫升測試儀
當高頻電流信號通過中性電極產生作用時,sw T 的“電子皮膚"產生與手術過程中病人皮膚及肌肉組織相同的溫度變化。 SWT 配套軟件針對連續性能檢測和信息網絡功能提供了所有必要的功能。
簡單直觀的用戶界面幫助用戶在短短幾分鐘完成中性電極性能的自動測試。提供專用測試軟件及其數據處理裝置。
1. 測試區域尺寸:12 cm x 22 cm
2. 空間分辨率:1 cm2
3. 溫度傳感器:16 x 26
4. 溫度傳感器陣列尺寸:16 x 26 = 416 Sensoren,
(每邊超出測試區域 2 cm) (AAMI HF 18: + 1 cm)
5. 可選高頻電流 700mA / 500mA / 350mA(成人 / 兒童 / 嬰兒中性電極 )
6. 負荷時間 60 s
7. 皮膚厚度 20mm / 15mm / 10mm / 5mm
8. 負荷后溫度測量時間 <1 s (AAMI HF18: 5 s)
9. 溫度分辨率 0.1°C (AAMI HF 18: 0.3°C)
10. 結合GB9706.202的 201.15.101.5 的標準要求對于帶有如下表所示患者重
量標記的中性電極,施加規定的試驗電流I 試 60 S 后立即測量,同息者接觸的任何 1cm2 面積或 1cm 范圍內,zui大溫升不應超過 6 ℃

11. 外形尺寸:535 x 203 x 364mm
12. 重量:14kg
13. 電源:100 ... 240 V AC, 47 ... 63 Hz
高頻電刀中性電極溫升測試儀

高頻電刀中性電極溫升測試儀 英文介紹
Testger?t für Neutralelektroden
Testing device for neutral electrodes
replaces tests on human volunteers
swaroTEST ist das erste Ger?t auf dem Markt, das den Test von elektrochirurgischen Neutralelektroden gem?? IEC 60601-2-2 erm?g- licht.
swaroTEST erzeugt in der ?elektronischen Haut“ dieselbe Temperaturerh?hung, die beim HF-Stromdurch- gang durch die Neutralelektrode, die Haut und den darun- ter liegenden Muskel entsteht, so wie dies w?hrend einer Operation auftritt. Bis jetzt hinderte die schwierige Mess- methode an Versuchspersonen die Krankenh?user und Fachh?ndler daran, diese wichtigen Qualit?tsmerkmale von Neutralelektroden regelm??ig zu testen.
Die Steuersoftware des swaroTEST enth?lt alle not- wendigen Eigenschaften für eine laufende Qualit?tskon- trolle und ist einfach in ein IT-Netzwerk einzubinden. Die Benützeroberfl?che ist leicht zu bedienen und der gesam- te Qualit?tstest l?uft automatisch in wenigen Minuten am swaroTEST ab.
swaroTEST is the first device in the market that enables the testing of the electrosurgery neutral electrodes according to IEC 60601-2-2.
swaroTEST generates the same temperature in- crease in the “electronic skin" as caused by the application of an HF-current through the neutral electrode, the skin and the underlying muscles, as it happens in the course of an operation. Up to now the difficult measurement meth- ods with volunteers prevented most hospitals and distribu- tors from regularly testing this essential quality features of neutral electrodes.
The control software of the swaroTEST brings all necessary features for continuous quality checking and integrates in common information network architecture. The user interface is easy to use and thus the whole elec- trode quality check procedure is performed automatically in a few minutes by the swaroTEST device.
Gr??e der Messfl?che (Vergoldete Messfl?che) | 12 cm x 22 cm | Size of measuring pad (gold-plated area) |
R?umliche Aufl?sung | 1 cm2 | Spatial resolution |
Temperatursensoren | 16 x 26 | Temperature sensors |
Fl?che mit Temperatursensoren (jeweils 2 cm über die Messfl?che hinaus) | 16 x 26 = 416 Sensoren, (IEC 60601-2-2: + 1 cm) | Size of temperature sensor array (exceeding the measuring area by 2 cm on each side) |
HF-Strom w?hlbar (Erwachsenen / Kinder / Baby Neut- ralelektroden) | 700mA / 500mA / 350mA | HF-current selectable (adult / children / baby neutral elec- trodes) |
Belastungszeit Standard (w?hlbar) | 60 s (10s … 300s) | Load time standard (selectable) |
Unterhautdicke | 20mm / 15mm / 10mm / 5mm | Hypodermis skin thickness |
Temperaturmessung nach Belastung | <1 s (IEC 60601-2-2: <15 s) | Temp. measurement after load |
Genauigkeit der Temperaturmessung | 0,3°C (IEC 60601-2-2: 0,5°C) | Accuracy of temperature measurement |
CQM-Simulation für Monitoring NE, Startimpedanz | 20 ? ... 200 ? ( = 100% ) | CQM simulation for monitoring NE Starting impedance |
CQM Impedanz Zunahme, relativ / Ohmwert bis zum Erreichen von AlarmArea Aa | 120% … 160% < 260 ? (IEC 60601-2-2:201.8.4.101) | CQM impedance increase relative / Ohm value Until achievement of alarm area Aa |
Erforderliche PC-Eigenschaften PC requirements
Messparameter Measuring parameters
Betriebssystem | Windows 98 / 2000 / XP | Operating system |
Serieller Ausgang | 9 pin Sub-D | Serial output |
Graphik Karte OpenGL-f?hig | min. 16 MB RAM, | Graphic card, qualified for OpenGL |
Empfohlene Bildschirmaufl?sung | 1024 x 768 | Recommended screen resolution |
Speicherbedarf auf Festplatte | ca. / approx. 5 MB | Hard disk space for software |
Arbeitsspeicher | min 128 MB | Memory RAM |
Technische Daten Technical Data
Dimension (Breite x H?he x Tiefe) | 535 x 203 x 364 mm | Dimension (width x height x depth) |
Gewicht (Zentraleinheit mit Mess- platte und Kabel) | 14 kg | Weight (main unit including meas- uring table and cables) |
Stromversorgung: | 100 ... 240 V AC, 47 ... 63 Hz | Power supply: |
Stromaufnahme bei 700 mA HF Strom, Leerlauf | 0,7 A @ 230 V, 1,7 A @ 110 V < 0,1 A | Supply current @ 700 mA HF current, standby |
請輸入賬號
請輸入密碼
請輸驗證碼
以上信息由企業自行提供,信息內容的真實性、準確性和合法性由相關企業負責,化工儀器網對此不承擔任何保證責任。
溫馨提示:為規避購買風險,建議您在購買產品前務必確認供應商資質及產品質量。